INSTALLATION NOTES

1. CUT 3 1/4" WIDE x ("X" MINUS 6") HIGH RECTANGULAR OPENING IN DUCT AT DESIRED LOCATION SO THAT MANIFOLDS ARE CENTERED VERTICALLY.

2. APPLY BEAD OF BUTYL RUBBER CAULK OR EQUAL AROUND OPENING IF DESIRED.

3. INSERT DISTRIBUTION TUBES IN OPENING WITH CONDENSATE PORT FACING "DOWN". UNIT MUST BE PLUMB (VERTICALLY AT SUPPLY HEADER AND HORIZONTALLY AT STEAM INLET) WITHIN 1/16" PER FOOT.

4. FASTEN SUPPLY HEADER TO DUCTWORK WITH (6) CS-163 DRILL QUIKS (INCLUDED). FOR UNITS OVER 3 FEET IN LENGTH, SUPPORT BRACKET MUST BE FASTENED AT ONE POINT ON TOP AND BOTTOM. HARDWARE PROVIDED BY OTHERS. THREADED ROD SUPPORT METHOD SHOWN IS ONE OPTION.

5. PLUMB AS SHOWN.

6. TOTAL UNIT WEIGHT (IN LBS.) IS APPROXIMATELY (6.28 x HEADER LENGTH [IN FEET]) + (1.83 x LENGTH OF DISTRIBUTION TUBE [IN FEET] x NUMBER OF TUBES)

7. CONSULT FACTORY IF OTHER MOUNTING ARRANGEMENTS ARE NECESSARY.